E-Ammonia synthesis Pilot plant
Description
This pilot plant is a dedicated configuration of Vinci Technologies’ AMS Ammonia Synthesis platform for e-ammonia production. It supports catalyst testing, kinetic studies and process development, with controlled high-pressure gas delivery, unreacted gas recirculation and product measurement.
Application and objectives
The unit enables researchers to evaluate iron-based catalysts during ammonia synthesis from green hydrogen and nitrogen via the Haber–Bosch process (N₂ + 3H₂ ⇌ 2NH₃), supporting research on fertilizer production and hydrogen carrier applications. Independent adjustment of gas feed rates, loop recirculation, pressure and reactor temperature profile allows the influence of operating conditions to be investigated across a 0.5 kg/h ammonia production capacity. Gas and liquid recovery supports product characterisation and material balances.
Feed preparation and gas recirculation
High-pressure hydrogen (up to 20 NL/min) and nitrogen (up to 10 NL/min) are supplied at 200 barg through thermal mass flow controllers equipped with automatic shut-down valves. Unreacted gas recovered after ammonia separation is 100 % recycled through a closed-loop recirculation module. This loop comprises a compressor (200 NL/min at 200 bar) operating in loop mode and a Coriolis mass flow controller rated up to 6.0 kg/h.
Reaction section
A 3D-printed static mixer and a 2.5–3 kW electric preheater condition the feed gases between 20 and 450 °C before they enter an upflow, pseudo-isothermal tubular reactor. The Inconel 625 configuration accommodates 0.7 to 1.3 L of catalyst across two 1.3 L tubes (2.6 L total), operating at a GHSV of 10,000 to 20,000 h⁻¹ with a 10 % single-pass conversion. Five electrical heating zones, five radial thermocouples and a thermowell provide temperature control and monitoring.
Separation and product measurement
Air-driven and pipe-in-pipe effluent heat exchangers cool the reactor outlet before a Vinci three-stage high-pressure separator (SS 316L, up to 200 barg, chilled jacket) and a medium-pressure separator/stripper (SS 316L, up to 25 barg, optional packing) recover liquid ammonia under level and pressure control. Liquid NH₃ passes through a Coriolis mass flow meter (0.2–2.0 kg/h, ±0.6 %) with density monitoring and an ammonia gear transfer pump. Vent gas is metered by a Coriolis mass flow meter (up to 2 kg/h, ±0.5 %) with pressure regulation and analysed via an online gas chromatograph for N₂ and H₂.
Operating basis and supervision
Operating limits are 200 barg and 450 °C (220 barg and 550 °C design), with typical test conditions ranging from 400 to 450 °C and 150 to 200 barg depending on the selected catalyst and experimental programme. Designed for installation in a general-purpose (non explosion-proof) area, the unit features a PLC, computer supervision software for unattended operation and a six-tier safety system.