Description
This pilot plant is a dedicated configuration of Vinci Technologies’ MOS — Methanol and Oxygenates Synthesis platform for the catalytic hydrogenation of CO₂ to methanol. It supports catalyst screening, kinetic studies and process development, with controlled gas delivery, unconverted gas recycle and product measurement.
Application and objectives
The unit enables researchers to evaluate catalyst activity, selectivity and stability during continuous e-methanol synthesis. Independent adjustment of hydrogen and CO₂ flow rates, recycle flow, pressure and reactor temperature allows the influence of operating conditions to be investigated. Gas analysis and liquid recovery support conversion assessment, product characterisation and material balances.
Feed preparation and gas recycle
Hydrogen and CO₂ are supplied through high-pressure lines equipped with thermal and Coriolis mass flow controllers. Fresh gases are combined with recycled unconverted gas in a static mixer. A hydraulic piston compressor equipped with Coriolis flow control regulates gas recycle. A heat exchanger using the reactor jacket fluid and an electric preheater bring the combined feed to the required reactor inlet temperature. Nitrogen is available for purging and inerting.
Reaction section
The feed flows upward through a jacketed fixed-bed reactor containing two catalyst tubes, with a total catalyst loading of approximately 1.3 L. The configuration accommodates industrially shaped catalysts. A common thermal-oil jacket, a six-zone furnace and an oil circulation loop equipped with a heater and air cooler provide temperature control and heat removal for the exothermic reaction. Axial temperature monitoring supports evaluation of the reactor temperature profile and near-isothermal operation.
Separation and product measurement
A cooled high-pressure separator and condenser recover crude methanol and water from the reactor effluent. Unconverted gas is returned to the feed section through the recycle compressor. The condensed liquid passes to a low-pressure stripper for degassing. An electronic high-pressure back-pressure regulator and a manual low-pressure back-pressure regulator control the separation pressures. Coriolis meters measure liquid product and off-gas flow. An automatic four-vial sampler cooled to 10 °C collects liquid samples before product recovery in a nitrogen-blanketed vessel mounted on a balance. An optional online NDIR/TCD analyser measures effluent gas composition.
Operating basis and supervision
Operating limits are 40 barg and 400 °C, with a nominal methanol production capacity of 1.5 kg/h. Actual production and test conditions depend on the selected catalyst, feed composition and experimental programme. A supervision workstation provides automated process control, data logging, alarms and safety interlocks.