MtJ - Methanol-to-Jet Pilot Unit

Description

This pilot plant combines two reaction trains from Vinci Technologies’ OPC platform with a hydrogenation train derived from its MHP platform. It converts methanol into kerosene-range hydrocarbons in three catalytic stages. Each train has dedicated feed metering, a furnace-heated tubular fixed-bed reactor and product recovery equipment, allowing each stage to be studied and mass-balanced independently.

Application and objectives

The unit supports catalyst evaluation and process development for methanol-to-olefins (MTO), light-olefin oligomerization and hydrogenation. Researchers can evaluate methanol conversion, light-olefin selectivity, C₈–C₁₆ olefin yield and the extent of hydrogenation. The nominal methanol feed rate is 3 kg/h, with an indicative kerosene-range production rate of approximately 1 kg/h.

Feed preparation and reaction section

Train 1:  Methanol-to-Olefins. Separate HPLC pumps with Coriolis mass flow control deliver methanol and water. The streams are vaporized separately and mixed before entering the reactor. Methanol is converted primarily to ethylene, with propylene and butenes also produced depending on the catalyst. The catalyst bed is diluted with inert material to reduce radial temperature gradients.

Train 2: Oligomerization. The C₂–C₄ olefin-rich gas recovered from Train 1 is compressed to 50 bar and stored in a cylinder. A gas mass flow controller meters the feed to the reactor, which converts the light olefins into higher olefins, targeting a mixture of linear and branched C₈–C₁₆ olefins.

Train 3: Hydrogenation. An HPLC pump with Coriolis mass flow control delivers the liquid olefins recovered from Train 2. A gas mass flow controller meters the hydrogen. The streams are mixed and preheated before entering the reactor, where the olefins are saturated to form the corresponding paraffins.

Separation and product measurement

Train 1 uses a chilled, jacketed gas–liquid separator to condense water from the reactor effluent. Coriolis meters measure the aqueous condensate and olefin-rich gas before collection and compression, respectively. In Train 2, a gas–liquid separator recovers the condensed oligomers. Unreacted light olefins can be recycled to the reactor through a compressor or discharged through an electronic back-pressure regulator. Coriolis meters measure the liquid product, recycle gas and discharge gas flows.

Train 3 uses high- and low-pressure separators to recover the hydrogenated liquid. An electronic back-pressure regulator maintains high-pressure separator pressure, and two automated valves transfer liquid to the low-pressure separator. Nitrogen stripping can remove residual dissolved gases. The gas outlets are combined and metered before venting, and a Coriolis meter measures the liquid product.

Optional kerosene fractionation

The hydrogenated product can be distilled to isolate and quantify the C₈–C₁₆ kerosene-range fraction intended for sustainable aviation fuel (SAF). The optional in-line distillation column supplied by Vinci Technologies receives liquid directly from the Train 3 low-pressure separator via a preheater. A water-cooled condenser recovers the overhead fraction, with part of the condensate returned as reflux and the remainder collected in a dedicated vessel. An off-line batch distillation column supplied by the client is also possible.

Operating basis and supervision


Train Operating pressure    Reactor temperature   
 Methanol-to-olefins     1.5 to 3 bar 450 to 500°C
  Oligomerization 25 to 40 bat 200 to 320 °C
 Hydrogentation 30 to 50 bar 150 to 250°C

Actual test conditions depend on the selected catalysts and experimental programme. An operator workstation provides a common interface for monitoring the three trains.

Features