CATATEST FTS - Bench-scale Fischer-Tropsch synthesis unit

Description

This laboratory-scale unit is a dedicated configuration of Vinci Technologies’ CATATEST platform, inspired by the FTS platform, for Fischer-Tropsch synthesis. It supports catalyst performance studies with reduced feed loads, kinetic testing and scale-up preparation, with controlled gas feed delivery and product measurement.

Application and objectives

The unit enables researchers to evaluate heterogeneous catalyst activity, selectivity and stability during the conversion of synthesis gas into liquid hydrocarbons. It supports both high-temperature (HT-FT, 350 °C, 30 barg, iron-based catalysts for C5–C12 gasoline-range hydrocarbons) and low-temperature (LT-FT, 220 °C, 30 barg, cobalt-based catalysts for C12–C20 diesel-range hydrocarbons) routes. Independent adjustment of gas flow rates, feed composition, pressure and reactor temperature profile allows the influence of operating conditions to be investigated. Reliable gas and liquid recovery supports product characterisation and accurate material balances.

Feed preparation and delivery


The gas feedstock—comprising CO₂, CO, H₂ and N₂—is individually regulated through Bronkhorst mass flow controllers (MFCs rated up to 60 bar) and mixed prior to entering the reactor. The system accommodates a total gas feed range of 0.15 to 50 Nl/h, with dedicated lines of 2.5–50 Nl/h for H₂ and 1.25–25 Nl/h each for CO and CO₂.

Reaction section

The mixed synthesis gas enters a 40 cm³ SS 316 down-flow fixed-bed reactor (450 mm length) accommodating up to 15 cm³ of catalyst. A three-zone conduction furnace (three independent 150 mm heating zones, operating from 50 to 550 °C) maintains a precise isothermal temperature profile along the catalyst bed.

Separation and product measurement

The reactor effluent first passes through a heated wax trap (up to 250 °C) equipped with a glass recovery bottle, followed by a condenser and a three-phase separator with NIR level detection where water is collected and liquid hydrocarbons are recovered. Liquid hydrocarbon samples are collected via an automatic selector into three 50 mL bottles. System pressure is regulated by an automated back-pressure regulator (BPR) up to 200 barg. The outlet gas leaves through a Coriolis mass flow meter (up to 2 kg/h) for pressure- and temperature-independent mass balance measurement, and can be routed to a customer-supplied gas chromatograph.

Operating basis and supervision

Maximum operating limits are 200 barg and 550 °C; actual test conditions depend on the selected catalyst and experimental programme. A PC supervision system with real-time trends, automatic data logging and Excel export provides process control, alongside a comprehensive safety system featuring alarms, hardwired fail-safe switches, emergency stop, relief valves and a ventilated enclosure.

Features